Yamaha motorcycle 02 warrior ecu diagnostic tool

#Yamaha motorcycle 02 warrior ecu diagnostic tool code#

List of self (opposite numbers menu list Decoder + nominal value):Р”В: 02 = barometric pressure as a percentage Р”В: 03 = the absolute pressure in the intake circuit Р”В: 05 = air temperature in the intake circuit Р”В¬ompletely closed, the indicator 12 to 22Р”В¬ompletely closed, the indicator 10 to 24Р”В: 21 = position sensor check point (neutral)Р”В: 60 = EEPROM, list of system errors (00 = no error, error code = 01-04 in the cylinders, if more than one memory errors, they are displayed alternately)Р”В: 61 = list of errors on the ignition module sensors (00 = no errors in memory, 11-70 = error codes for the components if more than one memory errors, they are displayed alternately)Р”В: 62 = number of errors in a memory unit (00 = no error, XX - number of errors, erase mistakes made by including the 'stop-motion') Р”В: 63 = subclass error code (only for error 24 if more than one value in memory, the value is displayed alternately) The inclusion of some components is made with the engine brake. In the range list from d01 to d59 performed a self-test system components. To move through the list from d01 to d64 need using the SELECT (up in the list) or RESET (down the list).

Once the dashboard displays the diagnostic mode (d01) button to turn off the stop of the engine.Р”РЃ. Once displayed on the screen dIAG press both buttons on the dashboard (SELECT + RESET) at ~ 2 seconds.Р”В§. Release the button, SELECT button to select 'dIAG' (in case the inscription on the dashboard there was another).Р”В¦.

Turn the ignition switch (button still hold) and wait for about 8 seconds until the dashboard inscription 'dIAG'.Р”Тђ. Simultaneously press SELECT + RESET on the dashboard and not let go.Р”В¤.

Turn off the ignition, the engine stop button to put in the ON position.Р”Р€. To enter the diagnostic mode and check the existing error codes in memory, do the following:Р”РЋ.

Yamaha motorcycle 02 warrior ecu diagnostic tool